Boiler Installation And Repair
Boiler Installation and Repair in Oakland County and Macomb County
Hydronic heat feels steady and comfortable. Your building stays warm without hot and cold swings. Fair Heating & Cooling installs, replaces, and repairs boilers across Oakland County and Macomb County. You get licensed techs, clean work, and clear prices. We service residential and light commercial systems, including cast iron boilers and high efficiency condensing models.
Boiler Systems We Install
- High efficiency condensing gas boilers with PVC or polypropylene venting
- Cast iron gas boilers with lined chimneys or approved vent systems
- Combi boilers for space heat and domestic hot water
- Boilers with indirect water heaters for fast, efficient hot water
- Radiant floor heating, panel radiators, and baseboard fin tube
- Multi zone manifolds with zone valves or pumps
When to Replace Your Boiler
Plan ahead. Replace before a mid winter failure. Look for these signs.
- Frequent lockouts or ignition failures
- Rising gas bills with no change in use
- Uneven heat or rooms that never reach setpoint
- Leaks, corrosion, or rust near the boiler or fittings
- Boiler age over 15 to 20 years for many models
- Cracked sections or unsafe draft readings
We inspect and give a direct answer. If a safe repair makes sense, we will say so. If replacement is the right move, you get firm options and pricing.
Right Sizing and Hydronic Design
A boiler must match the heat load and the emitters. Oversizing short cycles and wastes fuel. Undersizing struggles on cold days. We perform a load review. We check insulation, windows, and infiltration. We measure baseboard footage and radiator output. We size pumps and verify head loss. We design zoning for comfort and control. The result is smooth heat and lower fuel use.
Fuel, Venting, and Combustion Air
Most systems in Metro Detroit run on natural gas. We confirm gas line size and meter capacity. For condensing models we install approved venting with correct pitch and terminations. We route condensate to a proper drain with neutralizer when required. For non condensing models we confirm chimney condition or add a liner. We verify safe combustion air and draft. Safety comes first on every job.
Controls and Efficiency Upgrades
- Outdoor reset controls to match water temperature to weather
- Programmable or smart thermostats with zoning
- Variable speed pumps for balanced flow
- Air separators and dirt separators to protect pumps and valves
- Automatic fill valves with backflow protection
These upgrades improve comfort and reduce short cycling. They also extend equipment life. We explain each option in plain language so you can pick what helps most.
Radiant Floors, Radiators, and Baseboard
Hydronic heat works best when the emitters are tuned to the boiler. We balance loops, purge air, and set flow rates. For radiant floors we verify mixing and slab temperatures. For panel radiators we size valves and set lockshields. For baseboard we clean fins and check clearances. You get quiet heat and steady rooms.
Indirect Water Heaters and Combi Boilers
An indirect tank with a coil pairs well with a boiler. It gives fast hot water with strong recovery. A combi boiler saves space and offers on demand hot water. We size both solutions for your fixtures and family size. We set temperatures for comfort and safety. We install mixing valves when needed.
Our Boiler Installation Process
- Site visit. We inspect the boiler room, gas, venting, piping, power, and drains. We note emitters and zones.
- Proposal. You receive models, control options, drawings where needed, and firm pricing.
- Permits. We pull permits in your city and schedule inspections.
- Removal. We protect floors, drain the system, and haul away the old boiler.
- Piping and venting. We install near boiler piping, pumps or zone valves, air elimination, expansion tank, and approved venting.
- Startup. We fill, purge, set gas pressure, and program controls. We confirm draft or condensate handling.
- Commissioning. We record temperatures, pressure, delta T, and combustion readings where applicable. We label zones and valves.
- Training. We show you settings, shutoffs, and filter or screen maintenance.
Most residential installs finish in one to two days. Larger systems and repipes can take longer. We plan work around your schedule and keep areas clean.
Boiler Repair and Emergency Service
Cold weather failures need fast attention. We service cast iron and condensing boilers. We stock common parts and order specialty items with clear timelines.
- Ignition faults, flame failures, and lockouts
- Circulator, zone valve, and relay failures
- Pressure issues, relief valve discharge, and expansion tank problems
- Air in loops and noisy radiators
- Low heat, uneven rooms, or short cycling
- Sensor, limit, and control board errors
- Condensate leaks and blocked traps on high efficiency units
We diagnose with readings, not guesses. You get a clear cause and a firm price before work starts. We test operation after the repair and leave settings documented.
Annual Maintenance
Preventive care keeps boilers safe and efficient. We recommend a yearly visit before heating season.
- Combustion check and draft verification where applicable
- Clean burner, flame rod, and heat exchanger as needed
- Inspect and test safeties and limits
- Check pumps, belts if present, and valve operation
- Flush dirt separators and clean strainers
- Test expansion tank charge and system pressure
- Purge air and balance zones as required
Maintenance lowers fuel use, reduces breakdowns, and helps equipment last longer. We log model and serial numbers and keep a service history for your records.
Water Quality and Freeze Protection
Water quality drives reliability. Hard water and oxygen cause scale and corrosion. We test system water and advise on treatment. For homes with remote zones or garages we check glycol where used. We set proper mix and confirm freeze protection. We label fill points and leave a data sheet.
Safety and Code Compliance
We follow manufacturer instructions and Michigan code. That includes vent clearances, gas drip legs, shutoffs, backflow prevention, relief valve piping, and combustion air. We install CO alarms where needed. We do not leave safety to chance.
Service Areas
We install and repair boilers across Oakland County and Macomb County. Cities include Troy, Rochester Hills, Auburn Hills, Pontiac, Bloomfield Hills, Birmingham, Royal Oak, Ferndale, Farmington Hills, Novi, Sterling Heights, Warren, Roseville, Clinton Township, Macomb Township, Shelby Township, Utica, St. Clair Shores, and nearby communities.
Why Choose Fair Heating & Cooling
- Local team with more than 20 years of boiler work
- Licensed and insured technicians
- Load based sizing and clean hydronic design
- Firm pricing with permits and inspections included
- Strong follow up and maintenance plans
FAQs
How long does a boiler last
Cast iron boilers often reach 20 years or more with care. Condensing models can last long with yearly service and clean water. Usage and water quality matter.
Can you add zones to improve comfort
Yes. We add zone valves or pumps and update controls. Zoning helps balance temperatures and reduce cycling.
Do you service boilers from any brand
Yes. We service all major brands. We follow model specific steps and verify operation with readings.
Will a new boiler lower gas bills
High efficiency models and outdoor reset controls reduce fuel use when sized and set up right. Ductless does not apply to boilers, but emitter tuning does.
Do you handle permits and inspections
Yes. We pull permits in your city and meet the inspector. You receive documentation for records and for rebates when offered.
Get a Boiler Quote
Need boiler installation or repair in Oakland County or Macomb County. Call (248) 791-7075 or contact us online. Share your city, the boiler type, and any symptoms. We will schedule a visit and present clear options with firm pricing.